Ace FMC-150F-HYD-206 hydraulic driven cast iron pump 
Ace 206 hydraulic motor
Suction port: 220 flange and 1-1/2 inch NPT(F) thread
Discharge port: 200 flange and 1-1/4 inch NPT(F) thread
Viton® carbon/ceramic mechanical seal
Chemical resistant Valox® impeller
Stainless steel shaft and wear ring
Non self-priming
Performance:
83 m head (272 ft)
8.3 bar (120 psi)
560 lpm (148 gpm)
Dimensions:
267 x 223 x 241 mm (L x W x H)

The Ace 206 hydraulic motor:
1/2 inch NPT(F) hydraulic hose ports
Requires 26.5 lpm (7 gpm) maximum hydraulic fluid input 
Compatible with virtually all modern tractor hydraulic systems
Needle valve:
Allows for bypass of excess hydraulic fluid on open center hydraulic systems
Bypasses up to 34 lpm (9 gpm) on open center hydraulic systems
Has a threaded needle with a slotted end and lock nut
Coasting check:
This internal feature is standard on all Ace hydraulic motors
It protects the motor seal from pressure spikes created by the flywheel effect of the impeller when the pump is turned off
Reverse flow check:
Prevents damage by not allowing the pump to run backwards
For these hydraulic systems:
Pressure compensating closed center systems
Load sensing closed center systems
Open center systems up to 60.6 lpm (16 gpm)

Note:
1/2 inch hydraulic hose is recommended with Ace 206 hydraulic motors

The Ace Pumps story:
Ace Pumps began business in 1945
There have been considerable technological advances since Ace Pumps was founded.
Ace Pump Corporation has provided pumping solutions for the chemical application, off-highway equipment, air conditioning, and refrigeration markets
These varied applications have required Ace to successfully overcome a wide range of engineering challenges
In 1969 at the request of John Deere, Ace Pumps developed possibly the first hydraulic motor driven pump
Many of the original pumps are still operating today after more than 30 years of service
Today the Ace Pump Corporation is here at 1650 Channel Avenue, Memphis, TN 38113, USA